Cadac Seance - Manual (Page 29)

Séance 3-5
Revision SE2005-2 Séance Interface 7975
6145 7R#VHW#WKH#6pDQFH#ER[·V#RSWLRQV=
1. Press the options key in the main menu, see figure 3-3. The first option displayed
is the Séance IP address.
2. To change this option, press the edit key, see figure 3-4, which will display the
number edit screen as shown in figure 3-6.
3. The IP address can be edited by pressing the cursor key to move the cursor to
the number that requires changing and using the + or – keys to alter the number.
4. Pressing the save key will log the changed number and exit the edit screen but
this will not be saved until the options screen is exited. Changing the Séance IP
address will cause the program to re-start.
5. Use the quit key to exit the number edit screen and restore the original number.
6146 6pDQFH#2SWLRQV
There are three levels of options within the Séance. These are:
■ ■ ■ ■ Operator:Séance set-up options
■ ■ ■ ■ Debug:Various debugging options; only for use by CADAC-personnel.
■ ■ ■ ■ CADAC:System options; only for use by CADAC-personnel.
The option called ‘level clearance’ must be set to the correct level in order to display
and change the options. CADAC level can see all options. Debug level can see debug
and operator options but not CADAC options. Operator level cannot see either Debug
or CADAC options. The operator options are described below, while the Debug and
CADAC options are described in
4 Technical section . The options settings are dis-
played with the default value in bold type.