Cadac Seance - Manual (Page 25)

Séance 3-1
Revision SE2005-2 Séance Interface 7975
6 6pDQFH
This section contains information about the Séance setup and various user options
for the Séance interface.
614 %RRW#XS#VHTXHQFH#GLVSOD\V
When the Séance box is powered up it should run through a boot up sequence and
automatically run the Séance program. Figure 3-1 shows a block diagram of the
screens available during power up. There are a number of debug facilities available in
the util screen which is accessed by pressing and holding the right hand key during
power-up or when the Séance program restarts.
615 87,/#VFUHHQ
The UTIL screen allows the user to go back to the previous version of Séance pro-
gram, Séance options or TCP/IP options if the updating process fails.
Pressing the Séance key will prompt to revert to the last saved version of the Séance
program. Once reverted the newer version is saved as the last version so the two can
be toggled between using this function. Similarly the Séance options can revert to the
previous version as can the TCP/IP set-up (the Séance box’s IP address).
Revert to previous version
Seance PCTCP Config Select
Enter selection
SEANCE BROWSE DOS REMOTE util
Revert to previous pctcp.ini
No Yes
Revert to previous configuration
No Yes
Revert to previous seance.exe
No Yes
CMOS check
Starting Autoexec.bat
Loading Ethernet driver
Comp BNC HUB NONE
Loading packet driver
Starting Seance Util
Executing remserve
Exiting to dos
Power on sequence
FIG 3-1. Boot up sequence
Press key to select Ethernet I/F*
Message
only shows if
no Ethernet
connection
exists
Messages
only show if
Seance ver-
sion is earli-
er than 34267