BUG-O Systems Modular Drive System User Manual
Page 55
55
TROUBLESHOOTING GUIDE, CONT’D.
CAUTION: UNPLUG THE POWER CORD BEFORE OPENING OR CLOSING
THE CASE OR SERIOUS INJURY MAY RESULT.
1. Unplug the power cord.
Figure 3. Procedure for Opening the Master Drive Case:
Figure 2. Master Drive Accessory Port
4. Open the case.
2. Unbolt the Master Drive from
the carriage.
3. Remove ONLY the seven screws
as shown.
ACCESSORY PORT
AC
CHASSIS GROUND
AC
See also other documents in the category BUG-O Systems Equipment:
- HOB-O (18 pages)
- Side Beam System (17 pages)
- Flame Cutting (34 pages)
- Trac-Bug (21 pages)
- Programmable Shape Machine (31 pages)
- Programmable Shape Machine (22 pages)
- K-BUG 1200 (21 pages)
- Programmable Gantry System (36 pages)
- CWP-5 (40 pages)
- CWP-7 (41 pages)
- CWP-11 (47 pages)
- CWP-18 (41 pages)
- CB-1P (37 pages)
- CB-3 (30 pages)
- CW-5 (34 pages)
- CWE-5 (40 pages)
- CW-5AX (41 pages)
- CW-7 (43 pages)
- Elbow Cutters 3rd Axis (14 pages)
- CW-11 (46 pages)
- CW-18 (41 pages)
- SE-4PD (48 pages)
- SE-4PTD (40 pages)
- SE-4PD (43 pages)
- FTS-1025 (17 pages)
- BVW-1000 (26 pages)
- AGS-4100 (46 pages)
- Standalone CDS Linear Weavers (20 pages)
- BGW-6000 (47 pages)
- Standalone Pendulum Weavers (18 pages)
- DC IV v.2 (22 pages)
- UNI-BUG II (21 pages)
- PBM-2002 (17 pages)
- BEAM BUG III (23 pages)
- SPB-3000 (26 pages)
- Speed Weaver II (14 pages)
- UNI-BUG III (44 pages)
- CAS-2050 (20 pages)
- BUG-6554 (32 pages)
- CAS-2060 (20 pages)
- BUG-9874 (12 pages)
- STW-2000 (32 pages)
- STW-3000 (26 pages)
- Stiffener Welder (29 pages)
- MDS-1004 (14 pages)