BUG-O Systems Modular Drive System - Manual (Page 22)

22
WPD-1100 LINEAR WEAVER
The Linear Weaver and Weaver Control Module add weave welding capability to the Modular Drive System.
The Linear Weaver bolts onto the front of the carriage and the Weaver Control Module plugs into the top of the
Master Drive Unit. The optional MDS-1060 Remote Control Cable can be used to remote the Control Module.
FEATURES
The Linear Weaver and Weaver Control Module incorporate the following standard features:
• High torque, low inertia motor for precise stops and starts.
• High speed Linear Weaver for weaving, with independent control of right and left dwell times.
• High motor gearing which prevents the crossarm from moving when the unit is turned off.
• Closed loop speed control for adjustable and repeatable control of critical welding or cutting parameters.
• Closed loop position control to prevent drift from the center weld position.
• Clutch, to enable rapid installation or replacement of the weaver cross arm.
• Gun mounting group with adjustable racking block for accurate positioning of the gun.
• Contactor ON/OFF switch.
The figure below shows how the Linear Weaver and Weaver Control Module connect to the carriage and
Master Drive Unit.
INTRODUCTION
LINEAR WEAVER
CROSS ARM
LINEAR WEAVER
WEAVER
CONTROL
MODULE
CARRIAGE
MASTER DRIVE UNIT
WEAVER CLUTCH
(KNOB ADJUSTMENT)
GUN MOUNTING
GROUP