BUG-O Systems Modular Drive System - Manual (Page 49)

49
TROUBLESHOOTING GUIDE, CONT’D.
PROBLEM POSSIBLE CAUSE TEST BASE SYSTEM TEST PROCEDURE / REMEDY
Bad power supply.
1G Turn on the main power. The green LEDs L1 and L2 (see Figure 1)
will light if the power supply is OK.
If the LEDs are off, unplug the power supply output connector
(see Figure 1). The connector wiring is: White & RED is +15 V DC
(+/-2V). White & Black is DC ground. White & Orange is -15V DC
(+/-2V). Measure the voltages at the connector.
a) A bad voltage indicates a defective supply. Replace the supply.
b) Correct voltages indicate the power supply is OK, however,
there is a short in the equipment. Plug in the power supply
output connector. Perform test 1H.
Short circuit. 1H The Green LEDs L1 and L2 will light when the short is removed.
Unplug the following and monitor the LEDs to see if the short is
removed: 1) The control module 2) The speed card input power
connector (see Figure 1). 3) All connectors attached to the
interconnect card (see Figure 1), except the connector from the
supply.
If L1 and/or L2 never turned on, the interconnect card is bad.
Replace the board.
No tractor
speed
control and
display is lit.
Operator Error
(Stitch Control
Module).
2A Set the MODE switch to CONTINUOUS WELD and the CARRIAGE
TRAVEL switch to STOP. Turn the SPEED CONTROL clockwise.
Proceed to step 2C if the display does not increase. If the display
does increase, then turn the CARRIAGE TRAVEL switch to
FORWARD. Open the master drive case (Figure 3) and proceed to
step 2D if the tractor does not move forward.
Operator Error
(Weaver Control
Module).
2B Set the MODE switch to RUN , the CARRIAGE TRAVEL switch to
STOP and the START/STOP switch to START. Turn the SPEED
CONTROL clockwise. Proceed to step 2C if the display does not
increase. If the display does increase, then turn the CARRIAGE
TRAVEL switch to FORWARD. Open the master drive case (Figure
3) and proceed to step 2D. If the tractor does not move forward.
Bad DC power. 2C Open the master drive case (Figure 3). Unplug the power supply
output connector (see Figure 1). The connector wiring is: White
& Red is +15 V DC (+/-2 V). White & Black is ground. White &
Orange is -15 V DC (+/-2 V). Measure the voltages at the connector.
A missing or bad voltage indicates a bad supply. Replace the supply.
Faulty motor wiring. 2D Check the wires from the speed card to the motor for faults.
Rewire if needed.