BUG-O Systems Modular Drive System - Manual (Page 42)

42
SEMI-FLEX RAIL
SEMI-FLEX RAIL can be bent inside or
outside to a minimum radius of 15' (4.6 m)
or 30' (9.1 m) diameter without permanent
deformation.
AFR-3000 SEMI-FLEX RAIL replaces the old AFR-1000, 1010, 1020 and the later AFR-2000 rails. All the
rack-mounting holes on the AFR-3000 Semi-Flex Rail are slotted so that the rack can slide along the rail.
The length of the slots has been increased so that the rails can now be leapfrogged around a complete
circle. The tension of the screws holding the rack on the rail is adjusted so that the rack can be moved along
the rail with the AFR-2001 Rack-Adjusting Tool.
NOTE: Use at least four attachments (magnets or vacuum cups) on each SEMI-FLEX RAIL.
CAUTION: Bending beyond the recommended 15'-0" (4.6 m) radius may put
a permanent bend in the rail and break off some of the rack screws.
ITEM QTY PART NO. DESCRIPTION
1 16 AFR-1015 Spacer Washer
2 1 AFR-2001 Rack Adjusting Tool
3 1 AFR-3002 Splice Plate
4 1 AFR-3006 Rack
5 1 AFR-3009 Extrusion, Punched
6 2 FAS-0855 Flt Hd Soc Scr 1/4-20 x 1/2
7 2 FAS-0955 Flt Hd Soc Scr 1/4-20 x 1/2
8 16 FAS-1446-HW S.T. Slotted Hex w/Washer 10-32 x 5/8
9 16 WAS-0230 #10 Washer
PARTS LIST
4
6
1
7
9 8
3
5
A 2.75" (70mm)
B 4.0" (102 mm)
C .33" (8.5 mm)
D .500" (12.7 mm)
A
C
D
B
AFR-3000 / SEMI-FLEX RAIL
2
MIN. RADIUS
15' (4.6 m)
8'
(2.37 m)
8'
(2.37 m)