7 emc requirements, 8 operation of cem controller module, Emc requirements – Bronkhorst E-8000 User Manual
Page 42: Operation of cem controller module
Bronkhorst High-Tech B.V.
E-8000
9.17.076
42
4.3.7
EMC requirements
All system setups described in this manual carry the CE-mark. Therefore they have to comply with the EMC requirements as are
valid for this kind of equipment.
However compliance with the EMC requirements is not possible without the use of proper cables and connector assemblies.
For good results Bronkhorst HIGH-TECH B.V. can provide standard cables. Otherwise follow the guidelines as stated below. For
cables with 9-pin sub D-connectors:
Note: For FLOW-BUS SFTP data (patch)cable connection to RJ45 connectors follow the instructions of the supplier. It
is important to use shielded twisted pair cables and shielded RJ45 modular jack connectors.
4.3.8
Operation of CEM controller module
Upon connection of the power and signal cables, the CEM controller module is ready to
control the temperature of the heat exchanger. The temperature range of 0 to 200°C
corresponds with 0 to 5 V I/O signal (4 to 20 mA for current I/O).
For operation of the user interface we refer to chapter 3 of this manual.
i
www
For further instructions about the CEM system see manual 9.17.010 Manual 'CEM Controlled Evaporator and
Mixer'. This manual is available at the download section of our website: