Bronkhorst E-8000 - Manual (Page 20)

Bronkhorst High-Tech B.V.
E-8000 9.17.076 20
3.2.7 Setpoint slope
When entering the controller settings screen, the setpoint
slope parameter is already selected. Press
to enter the edit
mode.
Now you can change the slope time. Use and to select
a character and press to select the next character. Press
to exit the edit mode without changes.
Pressing after changing the final character will confirm
your input, the value will be sent to the instrument.
Use the
button to return to the measure readout screen.
3.2.8 Controller mode
Enter the controller settings screen from the settings menu.
Use
to select the controller mode parameter and press
to enter the edit mode.
The following controller modes can be selected:
selection description
analog input Setpoint via analog input
bus/rs232 Setpoint via bus or RS232 (E-8000)
rs232 Setpoint via RS232 only (E-8000)
fb ana slave Setpoint is factor of measure of
master on the bus, factor is set by
analog input.
analog slave Setpoint is factor of analog input
fb slave Setpoint is factor of measure of
master on the bus
actuator steering Controller is disabled, actuator
output is directly linked to setpoint
(50% setpoint output = 50%
actuator output)
actuator 100 perc. Controller is disabled, 100%
actuation
actuator 0 perc. Controller is disabled, 0% actuation
controller idle Controller is disabled, actuator
stays in actual position
setpoint 100 perc. Setpoint is 100%
setpoint 0 perc. Setpoint is 0%
Use or to select one of these control modes. Press
to cancel selection and exit the edit mode without changes.
When the required control mode is selected, press
to
confirm.