Bronkhorst E-8000 - Manual (Page 31)

Bronkhorst High-Tech B.V.
E-8000 31 9.17.076
3.2.27 Operator node addresses
When using a FLOW-BUS system you can change the node
address for each operating display.
From the setup menu select the bus item and press to
enter the bus settings screen. From the bus settings screen
press 3x
to move to the 'operator node'. Press to enter
the edit mode. In the edit mode, use and to change the
node address. When the required node address is visible,
press
to confirm.
Press to exit the edit mode without changes.
3.3 Advanced settings
3.3.1 Advanced menu
To enter the advanced screen, select 'advanced' in the
settings menu and press
. In the advanced menu you can:
menu item description
sensor change sensor filter settings
auto zero start sensor auto zero procedure
restore start restore instrument data procedure
The advanced menu is disabled by default. Refer to
section 3.4 'Security settings' for enabling or
password protect this menu item.
3.3.2 Sensor filter settings
To change the sensor filter settings select 'sensor' from the
advanced menu and press
to enter the 'sensor' settings
screen.
The sensor filter is split into a dynamic and a static part. Use
the
and button to select the dynamic or static
parameter and press to enter the edit mode.
In the edit mode, use and to change each character.
Press to select the next character.
When the final character is changed, press to confirm and
to exit the edit mode.
Press to exit the edit mode without changes.