Bronkhorst MASS-VIEW Series - Manual (Page 5)

BRONKHORST HIGH‐TECH
9.17.051 MASS‐VIEW® series Page 5
1 General Product Information
1.1 Introduction
MASS‐VIEW
®
instruments are accurate instruments for measuring and controlling the mass flow rate of
gases. These smart instruments offer multiple process values as input‐ or output parameters. Many
parameters can be changed on the instrument through the menu, other parameters can only be
changed using our digital interfaces.
This manual covers the general part of the MASS‐VIEW
®
series mass flow instruments for gases. It
covers the general instructions needed for the instruments.
1.2 Intended Use
The intended use of MASS‐VIEW
®
instruments is to measure or control gas flow rates of the
specified gas types as stored in the instrument. The gas has to be clean and dry.
1.3 Symbols
Important information. Discarding this information could cause injuries to people or damage to the
instrument or installation.
Helpful information. This information will facilitate the use of this instrument.
Additional info available on the internet or from your local sales representative.
1.4 Product Support References
MASS‐VIEW
®
instruments have modular instruction manuals consisting of:
‐ Instruction manual MASS‐VIEW
®
series (document nr. 9.17.051)
‐ Short form instruction manual MASS‐VIEW
®
series (document nr. 9.17.054)
‐ Operation instructions digital instruments (document nr. 9.17.023)
‐
Fieldbus/interface description: Manual : Hook‐up diagram :
RS232 Interface with FLOW‐BUS protocol 9.17.027 9.16.044
Modbus interface 9.17.035 9.16.066
‐ FlowPlot Manual
(document nr. 9.17.030)
‐ Hook‐up diagram MASS‐VIEW
®
series (document nr. 9.16.085)
‐ Dimensional drawing MASS‐VIEW
®
series (document nr. 7.05.697)
MASS‐VIEW
®
‐Controller series (document nr. 7.05.890)
These documents can be downloaded from our website: www.massflow‐online.com