Bematech MP-4000 TH Programmer's Manual User Manual
Page 75
MP-4000 TH POS Printer Rev.1.4
Programmer’s
Manual
22-aug-2007
Firmware Release: 1.5
75
this command and transmitting the status, depending on the receive
buffer status.
• When Auto Status Back (ASB) is enabled using GS a, the status
transmitted by GS r and the ASB status must be differentiated using
the table in Appendix III.
• The status types to be transmitted are shown below:
Paper sensor status
(n = 1, 49):
Bit Off/On Hex Decimal Status
for
ASB
0, 1
Off
00
0
Paper roll near-end sensor: paper adequate.
On
03
3
Paper roll near-end sensor: paper near end.
2, 3
Off
00
0
Paper roll end sensor: paper adequate.
4
On
(0C)
(12)
Paper roll end sensor: paper near end.
5, 6
Off
00
0
Not used. Fixed to Off.
- - - Undefined.
7
Off
00
0
Not used. Fixed to Off.
Bits 2 and 3: When the paper end sensor detects a paper end, the printer goes offline and does not
execute this command. Therefore, bits 2 and 3 do not transmit the status of paper end.
Drawer kick-out connector status
(n = 2, 50):
Bit Off/On Hex Decimal Function
Off
00
0
Drawer kick-out connector pin 3 is LOW.
0
On
01
1
Drawer kick-out connector pin 3 is HIGH.
1-3 -
-
-
Undefined.
4
Off
00
0
Not used. Fixed to Off.
5, 6 -
-
-
Undefined.
7
Off
00
0
Not used. Fixed to Off.