Bematech MP-4000 TH Programmer's Manual - Manual (Page 59)

MP-4000 TH POS Printer Rev.1.4 Programmer’s Manual
22-aug-2007
Firmware Release: 1.5 59
ESC c 3 n
[Function] Select paper sensor(s) to output paper end signals.
[Format] ASCII ESC c 3
n
Hexadecimal 1B 63 33 n
Decimal 27 99 51 n
[Description] Selects the paper sensor(s) to output paper end (PE) signals. Each bit
of n is used as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near-end sensor disabled 0
On 01 1 Paper roll near-end sensor enabled
Off 00 0 Paper roll near-end sensor disabled 1
On 02 2 Paper roll near-end sensor enabled
Off 00 0 Paper roll end sensor disabled 2
On 04 4 Paper roll end sensor enabled
Off 00 0 Paper roll end sensor disabled 3
On 04 8 Paper roll end sensor enabled
4-7 - - - Undefined
ESC c 4 n
[Function] Select paper sensor(s) to stop printing.
[Format] ASCII ESC c 4
n
Hexadecimal 1B 63 34 n
Decimal 27 99 52 n
[Description] Selects the paper sensor(s) to output paper end signals. Each bit of n
is used as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near end sensor disabled. 0
On 01 1 Paper roll near end sensor enabled.
Off 00 0 Paper roll near end sensor disabled. 1
On 02 2 Paper roll near end sensor enabled.
2-7 - - - Undefined