Bematech MP-4000 TH Programmer's Manual - Manual (Page 62)

MP-4000 TH POS Printer Rev.1.4 Programmer’s Manual
22-aug-2007
Firmware Release: 1.5 62
GS V m (n)
[Function] Select cut mode and cut paper.
[Format] ASCII GS V
m (n)
Hexadecimal 1D 56 m (n)
Decimal 29 86 m (n)
[Description] Selects a mode for cutting paper and executes paper cutting. The
value of m selects the mode as follows:
m Print mode
1, 49 Partial cut (one point left uncut)
66 Feeds paper (cutting position + [n × (vertical motion unit)]),
and cuts the paper
[Details] When
m
= 1, n isn’t needed and will be treated as normal data.
ESC ( A pL pH fn n c t1 t2
[Function] Activate buzzer.
[Format] ASCII ESC ( A 05 00 a d c t1 t2
Hexadecimal 1D 28 41 05 00 61 64 c t1 t2
Decimal 29 40 65 5 0 97 100 c t1 t2
[Description] Beeps the integrated beeper.
c
specifies times of beeping.
t1
specifies beeping time (t1 × 100 ms).
t2
specifies time for stop beeping (t2 × 100 ms).
[Notes]
This function repeats integrated beeper control of [(t1 × 100 ms) beep/
(t2 × 100 ms) stop] c times.
ƒ If this command is newly processed during beeping of the buzzer, the
current process for beeping the buzzer is stopped and the new
process for beeping the buzzer is started.
ƒ Integrated beeper beeping by this function stops due to any of the
following factors:
- Finish specification of c.
- Reset or power off.