Belshaw Adamatic TG25 Thermoglaze - Manual (Page 46)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
22 MN-1728EN Thermoglaze 25 TS
General:
Figure 1, above, shows the location of programming/navigating buttons on the face of the Altivar 11
(Belshaw P/N: VFD-0017). Figure 2 shows the navigation paths to various programming parameters.
The following has been adapted from the ATV11 Technical Manual which can be found at
http://ecatalog.squared.com/pubs/Motor%20Control/AC%20Drives/Altivar%2011/VVDED302026US.pdf
Programming:
Using Figures 1, and 2 navigate to the following programming parameters and set them as shown below
in Table 1. Items listed as default are set at the factory and should be verified.
The parameters in unshaded boxes can only be modified when the controller is stopped.
Remove jumper wire from terminal 15 to stop drive.
The parameters in shaded boxes can be modified with the controller operating or stopped.
MENU PARAMETER SECONDARY
PARAMETER FUNCTION SETTING
1 st Level ACC Acceleration ramp time
(sec.) 3 (default)
dEC Deceleration ramp time
(sec.) 3 (default)
LSP Low Speed (hz) 0 (default)
HSP High Speed (hz) 50/60 (default) based on motor
Hz
ItH Motor thermal current
(amps) 2.1
(Set to motor nameplate amps)
Alt Configuration of Analog
Input 5U (default)
drC UnS Motor voltage (volts) 230
(Set to motor nameplate
voltage)
FrS Motor frequency (hz) 60
(Set to motor nameplate
frequency)
nCr Motor current (amps) 2.1
(Set to motor nameplate
current)
COS Motor power factor .80
(Set to motor nameplate power
factor (sometimes labeled ‘pf’))
FUn tCC ACt 2-wire control 2c (default)
tCt Type of 2-wire control LEL
rrS Reverse operation nO
PS2 L1A Assignment of L1A nO
L1b Assignment of L1B nO
PI PIF Assignment of PI
function feedback nO (default)
rSF Fault reset nO (default)
bFr Motor Frequency (hz) 60 for domestic machines
(default).
50 for AS/NZ, and CE
machines;