Belshaw Adamatic TG25 Thermoglaze - Manual (Page 27)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Thermoglaze 25 TS MN-1728EN 3
area. Refer to Section 2 of the Operator’s
Manual for cleaning instructions. (With
optional auto-water fill only)
WARNING
If water is spilled while cleaning the
thermolizer, be sure to dry the floor
thoroughly.
7. Install screen rack angles onto angle
supports by tilting the angles up and sliding
the flange into the notches of the supports.
See Figure 2-1.
Figure 2-1
8. If not already done, remove the packing
material from the control box and the put
water reservoir cover in place over the water
reservoir.
9. Place the control box into the cabinet, push
the cord through the hole in the bottom to
the right of the control panel, and close the
cord opening cover plate.
10. Remove the protective covering from the
Plexiglas doors. Clean the doors with warm
water.
11. Insert the hinge pin on the right side of the
door into place, and then slip the left side
hinge pin into the slot.
WARNING
Pull down and away when opening door on
Thermolizer as not to dislodge door from
hinges. Loose door may cause injury.
Note: due to vibration in shipping, the door
handles might get out of adjustment. To
adjust door handles: loosen the screws which
fasten the handle to the Plexiglas door, adjust
position of the handle so it just clears the
bottom of the door above when both are
closed, and tighten the screws. If more than
one door handle requires adjustment, start
with the one nearest the top of the proofer and
work down.
12. Turn the control box power switch to the off
position (see Operation Instructions)
13. Connect Thermolizer cord to power source
provided from the ThermoGlaze main power
box.
14. Keep this manual for future reference. Put it
where you know you can find it.
Initial Cleaning
Remove all the packing materials. Wipe the
Thermolizer with a soft, damp cloth. Dry these
areas completely.