Belshaw Adamatic Mark VI Donut Robot - Manual (Page 56)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
20 MN-1032EN Donut Robot Mark VI TS
THE MOTOR OVERHEATS.
Possible Causes What To Do
The power requirements of the machine do not
match the power source. Supply the correct power as specified on the data
plate.
WARNING
To avoid being burned or electrocuted, before
doing the following, turn off the machine, allow
the shortening to cool, and disconnect the
machine from the power source.
The motor is binding. Repair or replace the motor.
The motor is defective. Repair or replace the motor.
THE CUTTER CUTS DOUBLE WHEN YOU HAVE SELECTED ONE CUT PER
POCKET.
Possible Causes What To Do
WARNING
To avoid being burned or electrocuted, before
doing any of the following, turn off the machine,
allow the shortening to cool, and disconnect the
machine from the power source.
The nylon brake dog is binding on the cutter
brake motor. Loosen the brake dog. If the spring is missing or
weak, replace it. If the brake dog is worn, replace it.
An internal wire is interfering with the nylon
brake dog. Move the wire.
The arm on the cutter head microswitch is bent. Bend the arm back into position or replace the
microswitch.
The wires on the cutter head microswitch are
reversed. Make the correct connections.