Belshaw Adamatic Mark VI Donut Robot - Manual (Page 54)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
18 MN-1032EN Donut Robot Mark VI TS
THE HEATING ELEMENT FAILS TO MAINTAIN THE PROPER
TEMPERATURE.
Possible Causes What To Do
The input voltage is incorrect. Supply the correct power as specified on the data
plate.
Sediment has accumulated around the
thermostat bulb. WARNING
To avoid being burned, turn off the machine and
allow the shortening to cool.
Clean to remove the sediment. (You should clean the
Donut Robot regularly and thoroughly.)
The thermostat has been calibrated incorrectly. Recalibrate the thermostat.
The thermostat is defective. WARNING
To avoid being burned or electrocuted, turn off
the machine, allow the shortening to cool, and
disconnect the machine from the power source.
Replace the thermostat.
THE DONUTS DROP AT THE WRONG TIME.
Possible Cause What To Do
The hopper swing is adjusted incorrectly. WARNING
To avoid injury, turn off the machine.
Adjust the hopper swing. See “Adjusting the
Hopper” in Section 1, “Installation,” of the
operator’s manual.