Installation – Belshaw Adamatic Mark VI Donut Robot User Manual
Page 46

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
10
MN-1032EN
Donut Robot Mark VI TS
Installation
1. Unplug the cutter head power cord of your
Donut Robot.
2. Release the plunger from the cutter head.
3. Unscrew and lift off the hopper assembly.
4. Lift off the cutter head and swing column
assemblies.
5. Lift the outfeed end of the Feed Table and
set the brace under the trip shelf over the
edge of the kettle.
WARNING
To avoid injury, make sure that the Feed
Table is turned off before proceeding.
6. Plug the Feed Table power cord into the
outlet on the end of the heater head.
7. Set the Donut Robot to cut one cut per
pocket.
This manual is related to the following products: