Belshaw Adamatic Mark VI Donut Robot - Manual (Page 29)

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark VI OM MN-1032EN 25
5. Attach the filter assembly to the lower part
of the siphon tube, as shown in Figure A-5.
To do this:
a. Slide the opening in the filter mounting
bracket around the siphon tube.
b. Adjust the filter mounting bracket
vertically to ensure that the filter does
not touch the valve assembly.
c. Tighten the screw that holds the filter
mounting bracket to the siphon tube.
d. Tighten the screw that holds the filter
retaining ring to the filter mounting
bracket.
WARNING
Make sure that both screw in the filter
assembly are tight. If they are not, the
filter assembly might slide off of the siphon
tube during operation, causing shortening
to splatter.
6. Place a five-gallon metal container under the
filter.
WARNING
Do not use a plastic container. Hot
shortening could melt the container,
possibly burning you and getting
shortening on the floor. Shortening on the
floor could cause you to slip or fall,
resulting in injury or even death.
Operation
1. Compress the bulb quickly and release it
quickly. Do this only once. Shortening
should flow into the container.
CAUTION
Do not compress the bulb more than once.
Doing so could allow hot shortening to get
into the bulb, damaging your equipment.
2. Watch the container as the shortening flows
into it. If the shortening rises to within 2”/
5 cm of the top of the container, do the
following:
a. With one hand, hold the siphon by the
handle. With the other hand, loosen the
thumb screw that holds the siphon
assembly to the mounting bracket on the
lip of the kettle.
b. Slowly lift the siphon assembly so its
opening is above the shortening. Do not
remove it from the mounting bracket.
c. Tighten the thumb screw.
d. When the shortening stops flowing and
the valve closes, move the container out
from under the filter.
e. Place another five-gallon metal container
under the filter.
f. With one hand, hold the siphon by the
handle. With the other hand, loosen the
thumb screw that holds the siphon
assembly to the mounting bracket on the
lip of the kettle.
g. Slowly lower the siphon assembly so its
opening is near the bottom of the kettle.
h. Tighten the thumb screw.
i. Restart the siphon, as explained in
step 1.
j. Continue watching the container and
repeat the above procedure as needed.