Basler Electric BE1-79M User Manual
Page 6
iv
BE1-79M Introduction
9170100990 Rev N
Manual
Revision and Date
Change
G
Changed Style Number Identification Chart first character from A to B
in response to ECA 12237.
Changed operational Test Procedure, Section 4 to improve
procedures and correct typographical error.
Added old Style Number Identification Chart to Section 7.
F
Manual revised to support the following relay changes:
o
Six additional control output options.
o
Two additional reclose time delay options.
o
Y-type power supply option.
o
Reset timer 1-100 second time delay option.
o
Four additional special contact assignments options.
o
A four function field selectable logic switch.
o
Moved sensing input power module from outside the case to
inside the case.
Added Section 7, Difference Data, to support BE1-79M Relay revision
D and previous.
E
Operational test procedure revised.
Pages 5-5 and 5-6 added.
Section 6 added.
D
Page 3-9: Subsection entitled Reclosing Event Memory rewritten for
clarification.
Pages 4-2 through 4-5: Operational test procedure revised.
Pages 5-2 through 5-4: Subsection entitled Test Plug Adapter added.
Added Qualifications to specifications listing, revised isolation test
and dielectric test.
C
Page 3-2: Added footnote to Table 3-1.
Added two paragraphs beginning with “Each reclose attempt…”
Page 3-7 Figure 3-2 corrected.
B
Page 3-3: Subsection entitled Instantaneous Trip Enable clarified.
A
Manual revised to reflect software changes, which introduced an
additional category (Unsuccessful Reclosers) to the Reclose Event
Memory.
—, 01/86
Initial release