Datalogic Scanning MAGELLAN 8500 - Manual (Page 380)

A-2 Magellan ® 8500 Scanner
Indicator LEDs
The green LED indicates scanner status, and the yellow LED is primarily
used to show scale status as described in Table A-1 below:
Table A-1. Green and Yellow LED Functions
LED
INDICATION
DURATION COMMENT
Scale at Zero
a
Yellow LED on steady
The scale is at rest and reads zero weight.
Scanner Active
a
Green LED on steady and dim The scanner is ready for operation. Scanning is
immediately available.
Good Read
Indication
a
Green LED - bright flash
Indicates a bar code has been read and decoded.
Program Mode
Indication Green LED - Continuous flashing Indicates the scanner is in Label Programming
Mode. Cycle power to exit Programming Mode.
Sleep Mode
Indication Green LED blinks at a 2-second rate
The scanner motor and/or laser have automati-
cally switched off and the unit has entered Sleep
Mode due to extended inactivity.
Host Disabled
1-second off, 1/10-second on
Host has disabled scanning.
Field Replace-
able Unit (FRU)
Warning (Error
Mode)
Audible low tone 3 seconds.
Alternating Green/Yellow LED flashes
continuously.
Serves notice that a fatal FRU failure has been
detected. Consult Error Codes in Section 4 for
more details. If a low tone is heard, but continuous
flashing is not observed, the scanner can still func-
tion in a limited capacity. Call systems support for
service in either case.
FRU Indication
Green LED flashes a coded
sequence in concert with the speaker.
Occurs ONLY upon Volume/Tone button push fol-
lowing a FRU warning. Enables service techni-
cians to identify FRU failures.
a. Certain functions of the Green and Yellow LEDs are selectable to be enabled or disabled. Your scanner
may not be programmed to display all indications.