Label id: set individually per symbology – Datalogic Scanning I GD4100 User Manual

Page 117

Label ID

Product Reference Guide

115

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:

1. Scan the ENTER/EXIT barcode.

2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-

fix) by scanning the appropriate barcode in the section "Label ID Control"on page

117

Reference

Figure 9

for Label ID positioning options if multiple identification features are

enabled.

3. Scan a barcode to select the symbology for which you wish to configure a custom Label

ID from the section

Label ID Symbology Selection, starting on page 118

4. Determine the desired character(s) (you may choose up to three) which will represent the

Label ID for the selected symbology.

5. Turn to the

ASCII Chart

on the inside back cover of this manual and find the equivalent hex

digits associated with your choice of Label ID. For example, if you wish to select an equal
sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to

Keypad, starting on page 301

and scan the barcodes representing the hex characters deter-

mined. For the example given, the characters ‘3’ and ‘D’ would be scanned. More exam-
ples of Label ID settings are provided in Table

NOTE

6. Scan the ENTER/EXIT barcode to exit Label ID entry.

7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.

This completes the steps to configure a Label ID for a given symbology.

Figure 9. Label ID Position Options

Prefix

Suffix

Label ID

Bar Code Data

Aim ID

If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.