Avery Dennison A64 CS Stacker - Manual (Page 8)

8
E r r o r M e s s a g e s
Error Messages are shown on the display and the ERROR light flashes. Press STOP/START to clear the error
message and return to READY.
Error Action
OUT OF PAPER There are no tags in the stacker. Check to see if
the printer is out of supply.
PAPER JAM Tags have jammed in the stacker or the sensor is
blocked or dirty. Check the paper path for the jam.
Make sure the sensor is positioned properly and
is not blocked. Clean the sensor.
PUSHER JAM The pusher assembly is jammed. Check for
proper alignment of the pusher assembly. The
pusher assembly is where tags are guided and
pushed onto the stacker. Look for blockage in the
stacker area.
KNIFE JAM Tags are jammed at the knife.
Remove any jammed tags.
STACKER FULL The stacker tray is full of tags. Remove the
stacked tags from the tray.
INTERLOCK OPEN The knife assembly is open, or the plastic shield is
not secure (if so equipped). Close the knife
assembly or plastic shield so it is completely
latched.
INTERNAL ERROR 01 An internal time-out occurred. Use Motor on the
Service & Diagnostics menu to check all motors
for proper functioning.
CONFIRM MODES The non-volatile RAM area is not initialized, or the
RAM area is corrupted. Set the proper modes and
continue.
If you cannot fix a problem, call service.