Avery Dennison A64 CS Stacker - Manual (Page 6)

6
About the Menu Overview
The stacker has three mode menus shown below.
Press the MODE key to navigate through the main menu and display each mode.
Press START/STOP to select a mode. Use the ARROW keys to select options within a mode.
Mode Selection Customize Modes Service & Diagnostics
1. Standard Notch 1. Standard Cut Master Cutline Adjustment
2. 1.222 Swiftach 2. 1.222 Swiftach Sensor Status
3. 1.250 Swiftach 3. 1.250 Swiftach Cycle Count
4. 1.375 Swiftach 4. 1.375 Swiftach Reset to Factory Defaults
5. User defined 5. User defined Motor Tests
6. User defined 6. User defined Web Test
7. User defined 7. User defined Knife Motor Test
8. User defined 8. User defined Transport Motor Test
9. User defined 9. User defines Pusher Motor Test
10. User defined 10. User defined Check LCD
Check Keypad
Check Memory
For each specify: For each specify: Sensor Trip Points
Flags? YES/NO/EXT Sensor Type: Transmissive Sensor Adjust
Transmissive Reflective Sensor Adjust
Reflective Flag Sensor Adjust
Offset: mm LCD Contrast Adjustment
Speed Setup
Note: Modes 5 through 10 display in Mode Selection only after they are defined in the
Customize Modes menu.