beautypg.com

Avery Dennison A64 CS Stacker User Manual

Page 4

background image

4

Setting the Flag Sensor

The flag sensor is located on the bottom of the knife assembly and is used to cut tags with a printed
flag mark.

Note:

When the position of the flag sensor is set correctly, the FLAG light flashes as tags pass
the sensor.

• Make sure the stacker is disabled. The stacker is disabled when the READY light is red.
• Place a sample tag against the guide on the knife assembly.
• Loosen the sensor thumbscrews and slide it until the arrow is pointing to the middle of the flag mark.
• Tighten the thumbscrews

Setting the Reflective Sensor

The Reflective Sensor is located behind the knife assembly, visible from the bottom of the stacker.
The reflective sensor can be moved by hand. Normally, no adjustment is necessary for this sensor.

Flag Mark

Arrow

Thumb-

screws