Avery Dennison Monarch 932 Stacker - Manual (Page 7)

S t e p 2 - L e v e l t h e S t a c k e r
1. Check the distance between the rollers and the knife. Make
sure the rollers are not touching the front of the knife or too
far from the knife. If incorrect, follow the steps below. If
correct, skip this step and move on to Step 3 - Connect the
Power Cord.
Note: The ideal position for the stacker is with the end of tray
slightly down.
2. Loosen the locking nuts with a wrench.
3. Make sure the stacker’s feet are flat on a level surface.
You can raise or lower the feet by turning them.
4. Evenly adjust both feet.
If the stacker is
¨ touching the knife case, lower the
feet.
¨ too far from the knife, raise the
feet.
5. Tighten the locking nuts.
Getting Started
1-3
Rollers
Knife
Locking
Nuts