Avery Dennison Monarch 932 Stacker - Manual (Page 19)

T R O U B L E S H O O T I N G
3
This section helps you correct some problems that may occur.
Problem Action
Stacker Full or 760
Warning Status
Code 1. Empty the stacker tray.
2. Place the tag weight against the tag stop.
3. Press Escape to clear the status code.
4. Continue printing.
The stacker may not be plugged into an outlet. Verify the
power connection.
Stacker Jam or 761
Status Code See “Clearing a Jam” in Chapter 2 for more information.
If the jam is not inside the stacker, check inside the knife or
printer.
Stacker does not
work. Make sure the stacker is properly connected to the printer.
See Chaper 1, “Getting Started” for more information.
Tags are stacked
too loosely. Empty the stacker tray. Turn the adjustment knob to a
lower setting.
Adjust the guide rails and the tag stop to the width and
length of the tags.
Tags are stacked
too tightly. Empty the stacker tray. Turn the adjustment knob to a
higher setting.
Tags are not
stacking level or
even. Adjust the guide rails and the tag stop to the width and
length of the tags.
Tags rub against the
side guide rails. The guide rails are too close to the tag. Adjust the guide
rails.
Tags have nicked
corners. Adjust the guide rails to the width of the tags. See Chapter
1, "Getting Started" for more information.
The guide rails will
not stay in place. Make sure the guide rails are in the grooves at the bottom
of the tray. See Chaper 1, "Getting Started" for more
information.
If you cannot fix a problem, call Service.
Troubleshooting
3-1