Avery Dennison Stacker - Manual (Page 21)

User / Service Manual Power Stacker
10/06 Rev. 1.09 21
Stepper motor
The stepper motor – if mounted to the power stacker – is an assembly and can not be
removed separately (motor and threading axle).
Assembly is like described in the TDI manual (platform).
• remove rear cover
• remove board and carrier
• disassemble platform mechanic
• open lower plate
• remove nut from thread axle
• remove platform block
• open motor screw (2) and remove
motor together with axle
• clean new motor and axle with
Aceton
• glue motor and axle together with
Loctite 648 – and assemble immediate
• position hexagonal nut around 20 mm
from the end of the axle
• move mechanic in vertical position and
press the threading axle down
• the glue is ready after 30 minutes – but
the mechanic can be assembled immediate
min. 20 mm
glue with
Loctite 648
press
down