Avery Dennison Stacker - Manual (Page 11)

User / Service Manual Power Stacker
10/06 Rev. 1.09 11
Magazine full
After the stack of label has reached the maximum – the platform is down in the lowest
position. This position is sensed via a micro switch (see picture) – the power stacker stops
and as well the printer is stopped witch a message on the display.
Removing a part of the stack (or the complete stack) the power stacker is moving up
automatically into the upper end position – the print job can be started again.
Attention: Start by accepting the message in the display again the print job.
end switch