Paxar Monarch 9855 RFID Printer User Manual

Page 90

You may need to clean the printhead, sensor, and platen roller:

◆

if there is any adhesive build-up in the supply
path.

◆

after printing approximately 3 rolls of thermal
transfer/thermal direct supplies or after each
ribbon.

◆

daily if your printer is in an excessively dirty,
hot, or humid environment.

◆

if you frequently receive supply error codes or
when you see voids or streaking in the print
as shown.

When you are using higher speeds (with 203 or
300 dpi), and/or increased print contrast, we
recommend cleaning the printhead after each
ribbon with isopropyl alcohol. If you still notice
build-up on the printhead or black streaks on your supply, order a
printhead CLEAN-STRIP (120350).

1. Turn off the printer and open the cover and printhead

assembly.

2. Remove the label roll and ribbon (when cleaning the

printhead).

3. Press down on the exit cover tabs to open the exit cover on

the front of the printer.

Voids

Streaks

Exit Cover

9-2 Care and Maintenance