Paxar Monarch 9855 RFID Printer - Manual (Page 40)

3. Press l or r to change the supply position. Pressing l
decreases the value (feeds less supply); r increases it
(feeds more supply).
4. Press Enter/Pause when the number you need appears.
Press Escape/Clear until you see the Main Menu.
M a r g i n P o s i t i o n
This function adjusts where the format prints horizontally on the
supply. The adjustments are in dots (0.0049 inch), which is the
smallest measurement the printer recognizes.
The width of the print area depends on your supply size.
Maximum width is four inches. When you move the image to the
right or left on the supply, avoid moving the image too close to
either edge, because it may not print.
Print too far to the left. Print too far to the right.
◆ If the data is too close to the left side, increase the number.
◆
If the data is too close to the right side, decrease the number.
Changing this setting only affects new
formats sent to the printer.
4-10 Setting Supply Options