Paxar Monarch 9855 RFID Printer - Manual (Page 69)

R e s e t t o D e f a u l t V a l u e s
To change the setting, from the Main Menu select Setup, Port
Settings, then Serial Comm. Then, follow these steps.
1. Press r until you see
SERIAL COMM
l
Reset
2. Press Enter/Pause.
Are you sure?
No
r
3. Press l or r to make your selection, then press
Enter/Pause. If you select "Yes," the following defaults are
restored: 9600 baud, No parity, 8 bit word length, and 1 stop
bit. Press Escape/Clear until you see the Main Menu.
P a r a l l e l C o m m u n i c a t i o n s
The parallel communications menu allows you to set the values
for the active parallel port. The values are listed in the table
below.
Option Choices Default
Port External/Internal External
Mode Compatible/IEEE-1284 Compatible
(Centronics mode)
P o r t
To change the setting, from the Main Menu select Setup, Port
Settings, then Parallel Comm. Then, follow these steps.
Setting Communications 6-5