Avery Dennison 9850 Addendum Version 3.0 - Manual (Page 4)

4
Downloading a Script
Follow these instructions to download a script from the DOS prompt. Set the
communication parameters using the MODE command. Then, prepare the printer to
accept a script.
1. From the printer’s Script Menu, press l or r until you see
SCRIPTS
Load Script r
2. Press Enter/Pause.
Script Load
Ready
Only one script can be loaded in the printer at a time.
Enabling a Script
To enable or disable a script:
1. From the Script Menu, press l or r until you see
SCRIPTS
l Enable Script r
2. Press Enter/Pause.
Enable Script?
l Yes
3. Use l or r to select either “Yes” or “No” and press Enter/Pause. Selecting
“Yes” starts the script. Selecting “No” stops the script. If you select “Yes,”
when you turn off the printer and turn it back on, the script automatically starts.