Avery Dennison Monarch 6017 Programmer Manual - Manual (Page 28)

4-4 Modifying Resident Fonts
L o a d i n g N e w C h a r a c t e r s
This step allows you to load the new characters at a particular position in
the set.
Command Summary
Command Description
-'D'--
-
Loads a character at a particular position.
The font to save the character in.
Value ASCII Fonts Extended ASCII
and ANSI Fonts
0 Large Normal
Standard Bold Large Normal
Standard Bold
Standard Normal
1 Standard Normal Large Rotated
Reduced Bold
Reduced Normal
2 Reduced Bold
Reduced Normal
The hex character code for the new character:
21 hex – 7F hex (ASCII) or 80 hex – FF hex
(Extended ASCII and ANSI).
#matrix# The hex data from the matrix describing the
new character (see “Defining New
Characters”).
The Next Step
You have now modified the character set. The next step is to save the font.
S a v i n g M o d i f i e d F o n t s
To save the modified font into flash memory, use ESC-'D'-FF hex. When the
fonts have been saved, the printer sends a ‘!’ character to the ha ndheld.
Then, it sends an ‘X’ character every 500 milliseconds.
Next, remove the battery and wait several seconds before replacing it.