Avery Dennison Monarch 9855 RFMP Quick Reference - Manual (Page 11)

11
8. Carefully feed the ribbon under both ribbon rollers and
printhead.
9. Align the ribbon and make sure it is straight and
centered throughout the path.
10. Tape the ribbon to the take-up core. Do not tape the
ribbon to the take-up reel.
11. Rotate the take-up core until the leader is past the
printhead.
12. Remove any slack in the ribbon by turning the take-up
reel clockwise.
13. Hold the printhead assembly by the printhead tab while
pressing down on the printhead release.
14. Close the printhead by pressing down on the thumb
well until you hear it click into place. Close the cover.
15. Press Feed/Cut several times to feed at least three
labels/tags to properly position the supply and the
ribbon.
P r i n t i n g
Before you print, make sure the printer is connected and
ready to receive data.
When you turn on the RFID printer, “Monarch Initializing”
flashes briefly and then you see “Print Mode Ready.” If an
error occurs while the printer is initializing, the error
message flashes briefly on the display and then you see
“Print Mode Ready.” The printer displays “Not available”
when you try to select the RFID menus if the module is
inoperative.
T a k e - u p C or e
T a k e - u p R ee l
R i b b o n
R o l le rs