Avery Dennison Monarch 9855 RFMP Quick Reference - Manual (Page 10)

10
L o a d i n g R i b b o n
1. Open the cover.
2. Unlock the printhead by turning the retaining latch.
3. Lift printhead assembly using the printhead tab until
the assembly locks into place.
4. Push the deflector tab down.
5. Slide the extra ribbon core on the take-up reel as far
as it will go with the "This End Out" writing facing out.
Use your empty ribbon core as the take-up core. The
take-up core only fits on the take-up reel one way.
6. Remove the new ribbon from the package. Do not
wrinkle or crush the new ribbon.
7. Slide the ribbon onto the back reel as far as it will go.
Carefully unwind a few inches of ribbon from the
bottom of the roll.
Note: Make sure the “This End Out” writing is facing
out. The ribbon roll only fits on the reel one way.
P ri n t h ea d
T a b
D e f l ec t or
T a b