Avalon Firestyles Surround Panels - Manual (Page 2)

Surround Panels (DVS/DVL EF II)
Page 2 of 2 17601428 - 2/25/14 © Travis Industries, Inc.
DVL / 33 DVI – Side Panel Installation
Top Panel and Trim Installation
Line up each side surround
panel and insert two screws from
the inside to secure in place.
5/16" Nutdriver
Pre-thread the holes on the surround
panels with the screws included in the
surround panel kit.
b
a
Run the power cord to
the side of the insert.
Top
Panel
Top Trim
"L" Bracket
Right Side Trim
Slot for on/off
switch and hole for
rheostat
(31 & 33 DVI Only)
a
"L" Bracket
Right Side
Trim
Top Trim
Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Micro (1/16”)
Standard
Screwdriver
Spring
Clips
Optional Knock-Out
An optional knock-out is provided if the power cord is
routed behind the surround panel.
Install the top panel so
the tabs insert into the
joggle clips on the top
panel
b