Avalon Firestyles Gas/Pellet Remote Thermostat - Manual (Page 2)

Wall Thermostat
SKU 99300650
Page 2 of 3 2/2/11 - 17601040 © Travis Industries, Inc.
Wire Connection - Gas Heaters
Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The thermostat
and wiring must be installed by a qualified installer.
The included wire allows the installer to connect the thermostat to the on/off switch on the heater. Follow
the directions below to install the splitter in series or parallel connection.
WARNING: Make sure all wiring is secure and does not contact hot or moving components.
NOTE: The newer switch has two terminals and is pictured below. Older switches
have four terminals. Use the top and bottom terminal on either side of the
switch when connecting the wires (see the illustration to the right).
Parallel Connection
On/Off Switch ON On/Off Switch OFF
Thermostat/External Switch ON Heater is ON Heater is ON
Thermostat/External Switch OFF Heater is ON Heater is OFF
To wire the heater in parallel, follow the directions below:
Series Connection
On/Off Switch ON On/Off Switch OFF
Thermostat/External Switch ON Heater is ON Heater is OFF
Thermostat/External Switch OFF Heater is OFF Heater is OFF
To wire the heater in series, follow the directions below: