Artesyn System Management Interface Based on HPI-B 2.0(Centellis 4620/4440) User's Guide (June 2014) - Manual (Page 34)

Software Installation and Configuration
System Management Interface Based on BBS HPI-B 2.0 (Centellis 4620/4440) User’s Guide (6806800P21D) 34
# snmpwalk -v 2c -c public localhost -m
/opt/bladeservices/share/snmp/mibs/SAI-HPI-SNMP-MIB-
B.01.01.mib hpib0101
4. In order to configure the SNMP master agent for SNMP V3, add the following line to
snmpd.conf
:
createUser LocalUser MD5 "LocalUserPassword" DES
"localUserPassword"
rwuser LocalUser
To test the SNMP V3 configuration, save the configuration file and perform a SNMP
walk by entering the following command at the ATCA-F125/F140 command line:
snmpwalk -v3 -n "" -l AuthPriv -u "LocalUser" -a MD5-A
"LocalUserPassword" -x DES -X "LocalUserPassword" -m
/opt/bladeservices/share/snmp/mibs/SAI-HPI-SNMP-MIB-
B.01.01.mib localhost hpib0101
5. If you are using SNMP V2 and want to enable SNMP traps to be sent to a host, enter
the following line to snmpd.conf
trap2sink public
is the IP address of the host where you want the traps to be sent to.
6. If you are using SNMP V3 and want to enable SNMP traps to be sent to a host, enter
the following line to snmpd.conf
trapsess -e -v 3 -n "" -l
-u -a MD5 -A
"" -x DES -X ""
Ip>:162
This creates a session with the host where the traps are to be sent to (as required by
SNMP V3).
An example entry might look as follows:
trapsess -e 0x800000000102030405 -v 3 -n "" -l AuthPriv -u LocalUser
-a MD5 -A "LocalUserPassword" -x DES -X "LocalUserPassword"
192.168.21.1:162