Artesyn System Management Interface Based on HPI-B 2.0(Centellis 4620/4440) User's Guide (June 2014) - Manual (Page 28)

Software Installation and Configuration
System Management Interface Based on BBS HPI-B 2.0 (Centellis 4620/4440) User’s Guide (6806800P21D) 28
2.3 Setting Up HPI Clients
This section describes how to install/configure HPI clients on node blades.
RmcpAllowedAuthsAdmin
Allowed authentication
mechanisms for privilege
level 'operator
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
RmcpGuid
RMCP group user id
16 hex bytes [01 02 03 04 05 06 07
08 09 10 11 12 13 14 15
16] - default guid
All zeros(16
bytes)
RmcpUser[X]
X is an integer
Ex: RmcpUser2, RmcpUser3,
RmcpUser4 etc
RMCP users
>
U -
username
P -
Password
Pr -
Privilege
MS -
Maximum
number of sessions
A -
Authentication
[RmcpUser[2,3,4,5,6]]
are available in config file
Ex:
RmcpUser6 =
"Administrator
Administrator admin 64
none md2 md5 straight"
NA
SelMaxEntries
Maximum number of
entries in the SEL
<0…N> [100] 1024
HPI_OEM_DISCRETE_SENSOR_D
EF_SEVERITY
HPI-B Daemon will set the
severity for the HPI events
of non-threshold sensors
based on the value
configured for this tag.
Note: If this tag is set to 3,
then change the
OPENHPI_LOG_ON_SEV
tag to
"INFORMATIONAL"
instead of "MINOR" so
that it logs events of
"INFORMATIONAL"
severity also into DEL.
<0,1,2,3> [3]
- informational
0
- critical
1
- major
2
- minor
Commented by default,
Please uncomment in the config
file for the tag to take effect.
0
- critical
daemon will
assign the default
"critical" severity
for the events of
non-threshold
sensors(discrete/
OEM)
Table 2-4 Plugin Specific Parameters (continued)
Tag Description Allowed values Default in Config. file Built-in Default