4 monitoring commands, 1 show-monitor-id, Table 4-16 – Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) User Manual
Page 62: Stop-test
Commands Execution
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49E)
62
]]>]]>
The following table provides the Stop-test command arguments.
Table 4-16 stop-test
Argument
Data Type
Description
Test ID
Integer
Type the unique ID of the Test that you want to stop
Dev Instance
Enum
Use list-device-instances CLI command to get
the equivalent enumerated value of supported Device
Instance
4.4
Monitoring Commands
The following list of commands are used for management of the InService Monitoring
functionality of ViewCheck.
Execute all commands related to monitors only after entering the specific device category
mode.
4.4.1
show-monitor-id
show-monitor-id
command displays the list of parameters that are monitored using the
InService Diagnostic. This command displays default monitor ID values of the parameters also.
Syntax for CLI
show-monitor-id
Syntax for XML