Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) - Manual (Page 24)

Installation of ViewCheck
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49E) 24
Username: Admin
Password:
Access granted
>enable
#configure terminal
BSF(config)#
BSF(config)#virExecEnv vee0
BSF(VEE-vee0)#diagnostic
BSF(diag-vee0)#
By default, the administrator user name and password are "Admin".
After logging into the ViewCheck CLI, you can list all supported commands by typing '?' on
the CLI console. Following is an example.
BSF(diag-vee0)#?
configure-error-strings User configurable error strings, notified
by ViewCheck when reported by the device.
configure-log-path Configures the log path where the resluts
are stored.
device-category Configure deviceCategory
diag-service Diag operation(start/stop/restart).
exit Exit from diagnostic
hw-inventory-list Provides the Inventory of Hardware (Type,
Vendor ID, Major Number, Minor Number and
any associated Details) as detected by the
Diagnostics Application.
list-all-tests Displays all the supported tests on the
Board.
purge-all-log All log files are Zipped and stored away.
purge-log Purge specific log file.
reload User can issue this command when there
are updates to the User XML.
set-log-level Sets the Log Level of Diagnostic
Application.