Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) - Manual (Page 56)

Commands Execution
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49E) 56
Example
BSF(diag-vee0)#switch-mode modeVal insm
Mode of ViewCheck is successfully changed to INSM
4.2.24 version
version
command displays the RPM versions of all the ViewCheck packages installed.
Syntax for CLI
version
Syntax for XML
</p><p style="position:absolute;top:502px;left:175px;white-space:nowrap" class="ft04"><InvokeMethod> </p><p style="position:absolute;top:525px;left:175px;white-space:nowrap" class="ft04"><Object> </p><p style="position:absolute;top:548px;left:175px;white-space:nowrap" class="ft04"><Class>diagnostic</Class> </p><p style="position:absolute;top:571px;left:175px;white-space:nowrap" class="ft04"><Name>vee0</Name> </p><p style="position:absolute;top:594px;left:175px;white-space:nowrap" class="ft04"></Object> </p><p style="position:absolute;top:617px;left:175px;white-space:nowrap" class="ft04"><Method>showVersion</Method> </p><p style="position:absolute;top:640px;left:175px;white-space:nowrap" class="ft04"></InvokeMethod> </p><p style="position:absolute;top:663px;left:175px;white-space:nowrap" class="ft04">]]>]]>
4.3 Test Management and Control Commands
This section describes the CLI commands used for test management and control of diagnostics
tests.
Execute all test management and control commands only after entering a specific device
category.
4.3.1 start-test
start-test
command allows to start and run a particular diagnostics test.