Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) - Manual (Page 23)

Installation of ViewCheck
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49E) 23
You can install the BSF using the following RPM commands:
 rpm -iv --nodeps --force ssf_main_rel---
..rpm

rpm -iv --nodeps --force ssf_csim_rel---
..rpm
 rpm -iv --nodeps --force ssf_diagnosticsTLS_rel---
..rpm
After the installation, the BSF binary files are installed at the /opt/ssf location.
The BSF applications can be started, stopped, and restarted using below script.
/opt/ssf/etc/config/S99SsfBsfRun.sh
To uninstall the BSF, execute the following RPM commands:
 rpm -e ssf_diagnosticsTLS_rel---
..rpm

rpm -e ssf_csim_rel---..rpm
 rpm -e ssf_main_rel---..rpm
3.4 Access and Execution of a Test Using CLI
You can access ViewCheck CLI using the following procedure:
1. Establish the secure shell using SSH or Putty.
2. Start the Telnet connection from an already established secure shell.
telnet localhost 11001
Trying :1...
telnet: connect to address ::1: Connection refused
Trying 127.0.0.1...
Connected to localhost.localdomain (127.0.0.1).
Escape character is '^]'.
Welcome to Emerson's SSF CLI
3. Type your username and password.