Artesyn RTM ATCA-F140 Installation and Use (July 2014) - Manual (Page 24)

Hardware Preparation and Installation
RTM-ATCA-F140 Installation and Use (6806800M97F) 24
1. Visually inspect the RTM and zone 3 connectors on the front blade for damage or bent pins
before attempting to insert a board. If any connector damage or pin damage is observed,
stop before inserting the RTM and send the damaged item through proper repair channels.
2. If the corresponding front blade is already installed, perform the following steps.
Otherwise skip to step 3.
 On the front blade, verify the face plate screws that secure the blade to the shelf are
tight.
 Deactivate the front blade. Unlatch the lower handle by squeezing the lever and the
latch together and turning the handle outward only enough to unlatch the handle from
the face plate. Do not rotate the handle fully outward.
 When the blue LED on the front blade is permanently illuminated, proceed to the next
step.
3. Ensure that the top and bottom ejector handles on the RTM are in the outward position by
squeezing the lever and the latch together.
4. Insert the RTM into the shelf by placing the top and bottom edges of the RTM in the card
guides of the shelf. Ensure that the guiding module of the front blade and RTM are aligned
properly.