Artesyn RTM ATCA-F140 Installation and Use (July 2014) - Manual (Page 15)

Chapter 1
RTM-ATCA-F140 Installation and Use (6806800M97F) 15
Introduction
1.1 Features
The RTM-ATCA-F140 provides the I/O connection for the ATCA-F140 switch blade towards the
back of the system. RTM-ATCA-F140 is directly connected to and powered by the front board.
The RTM-ATCA-F140 is a rear transition module (RTM) as defined in PICMG 3.0 Revision 3.0
Advanced TCA Base Specification and PICMG 3.1 Revision 1.0 Specification Ethernet/Fiber
Channel for AdvancedTCA Systems. It provides several Base and Fabric Channel Ethernet
interfaces connected to the front board through the Zone 3 connector.
The main features of the RTM-ATCA-F140 are:
 Single slot RTM form factor (70mm x 322mm)
 1x 40Gbit Ethernet uplink (FIX) according to IEEE 802.3ba with 1 QSFP+ type connector
 4x 10Gbit Ethernet uplinks (FIX) according to IEEE 802.3ap with 4 SFP+ type connectors
 2x 10Gbit Ethernet uplinks (BIX) according to IEEE 802.3ap with 2 SFP+ type connectors
 4x 1Gbit Ethernet interfaces (BIX) with 4 SFP type connectors
 Serial EEPROM accessible by front-blade IPMC
 Four status LEDs and ejector handle switch accessible by front-blade IPMC
1.2 Standard Compliances
The product is designed to meet the following standards.
Table 1-1 Standard Compliance
Standard Description
ANSI Fire Spread Criteria The product is designed to pass the ANSI T1.319-2002 fire
spread test method as well as the NEBS GR-63-CORE fire spread
test method.
AS/NZS CISPR 22 Class A
(Australia/New Zealand) The product complies with AS/NZS CISPR 22 Class A
(Australia/New Zealand), Limits and Methods of Measurement
of Radio Disturbance Characteristics of Information Technology
Equipment.