Artesyn MVME4100 Single Board Computer Installation and Use (June 2014) - Manual (Page 66)

Controls, LEDs, and Connectors
MVME4100 Single Board Computer Installation and Use (6806800H18G) 66
3.3.3.7 VMEbus P2 Connector
The VME P2 connector is a 160-pin DIN. Row B of the P2 connector provides power to the
MVME4100 and to the upper eight VMEbus address lines and additional 16 VMEbus data lines.
The Z, A, C, and D pin assignments for the P2 connector are the same for both the MVME4100
and MVME7216E, and are as follows:
24 GND A07 IRQ7* A14 +3.3V (Not Used) 24
25 Reserved (N/C) A06 IRQ6* A13 Reserved (N/C) 25
26 GND A05 IRQ5* A12 +3.3V (Not Used) 26
27 Reserved (N/C) A04 IRQ4* A11 Reserved (N/C) 27
28 GND A03 IRQ3* A10 +3.3V (Not Used) 28
29 Reserved (N/C) A02 IRQ2* A09 Reserved (N/C) 29
30 GND A01 IRQ1* A08 +3.3V (Not Used) 30
31 Reserved (N/C) -12V +5VSTDBY
(N/C) +12V GND 31
32 GND +5V +5V +5V +5V 32
Table 3-14 VMEbus P1 Connector Pin Assignments (continued)
Pin ROW Z ROW A ROW B ROW C ROW D Pin
Table 3-15 VME P2 Connector Pinouts
Pin P2-Z P2-A P2-B P2-C P2-D
1 SP1RX PMC1_IO2 +5V PMC1_IO1 E1-1+
2 GND PMC1_IO4 GND PMC1_IO3 E1-1-
3 SPITX PMC1_IO6 VRETRY_L PMC1_IO5 GND
4 GND PMC1_IO8 VA24 PMC1_IO7 E1-2+
5 SP1CTS PMC1_IO10 VA25 PMC1_IO9 E1-2-
6 GND PMC1_IO12 VA26 PMC1_IO11 GND
7 SP1RTS PMC1_IO14 VA27 PMC1_IO13 E1-3+
8 GND PMC1_IO16 VA28 PMC1_IO15 E1-3-
9 SP2RX PMC1_IO18 VA29 PMC1_IO17 GND