Artesyn MVME4100 Single Board Computer Installation and Use (June 2014) - Manual (Page 34)

Hardware Preparation and Installation
MVME4100 Single Board Computer Installation and Use (6806800H18G) 34
2.4 Configuring the Board
To produce the desired configuration and ensure proper operation of the MVME4100, you may
need to carry out certain hardware modifications before installing the module.
The MVME4100 provides software control over most options: by setting bits in control
registers after installing the module in a system, you can modify its configuration. The
MVME4100 control registers are described in the MVME4100 Programmer’s Reference.
Prior to installing PMC modules on the MVME4100 base board, ensure that all switches that are
user configurable are set properly. To do this, refer to
Figure 2-3 or the board itself, for the
location of specific switches and set the switches according to the following descriptions.
Figure 2-3 Switch Locations