Artesyn ARTM-9405 16x10GbE Installation and Use Guide (May 2014) - Manual (Page 55)

Safety Notes
ARTM-9405 16x10GbE Installation and Use (6806800P45F) 55
RJ-45 Connectors
The RJ-45 connectors on the face plate must only be used for serial console connections.
Connecting a telephone to such a connector may destroy your telephone as well as your board.
Therefore:
 Clearly mark TPE connectors near your working area as network connectors.
 Only connect TPE bushing of the system to safety extra low voltage (SELV) circuits.
 Make sure that the length of the electric cable connected to a TPE bushing does not
exceed 100 m.
If you have further questions, ask your system administrator.
Replacement/Expansion
Only replace or expand components or system parts with those recommended by Artesyn.
Otherwise, you are fully responsible for the impact on EMC or any possible malfunction of the
product.
Check the total power consumption of all components installed (see the technical
specification of the respective components). Ensure that any individual output current of any
source stays within its acceptable limits (see the technical specification of the respective
source).
Environment
Always dispose of used products according to your country’s legislation and manufacturer’s
instructions.