Artesyn ARTM-9405 16x10GbE Installation and Use Guide (May 2014) - Manual (Page 23)

Hardware Preparation and Installation
ARTM-9405 16x10GbE Installation and Use (6806800P45F) 23
2.5.2 Removing the RTM
This procedure assumes that your system is powered. If your system is unpowered, disregard
the blue LED and skip the respective step.
1. Unlatch the lower handle outward by squeezing the lever and latch together, and then turn
the handle outward until you feel a resistance.
2. The blue LED blinks indicating that the front blade has informed the shelfmanager to
power down the payload of both the front blade and RTM, and that the power-down
process is going-on.
3. Wait until the blue LEDs on the front blade and RTM are permanently lit.
Do not rotate the handle fully outwards.